Furnace Installation in Point Pleasant, WV
A new furnace here will run from October through April every year. Tell us about the house, and a licensed contractor who covers Mason County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of heat, and nights that drop to 26 degrees
Point Pleasant needs a working furnace from October through April. That is seven months out of the year, with winter nights averaging 26°F. A new furnace here is going to run often and run hard, so it needs to be sized and installed to keep up with that stretch, not just the coldest week of it.
Most homes in West Virginia heat with electricity, and the area has seen its share of winter storms and wind events over the past ten years. A furnace that can hold up through outages and rough weather matters here. If you're installing a gas furnace, federal rules require non-weatherized models made since November 2015 to reach at least 80 percent AFUE, so any new unit will meet that mark.
- 7 months
- October through April, your furnace is on duty
- 26°F
- the average winter night it heats against
- 80% AFUE
- the federal minimum any new unit must meet
NOAA nClimDiv, 1991–2020 normals
West Virginia requires HVAC contractors to hold a state license.
The license is held by the contractor, not issued job by job, so it covers the business doing your install rather than a one-time approval for this furnace. West Virginia's Commissioner of Labor is the one testing and keeping record of who holds it.
For a furnace install, the license tells you the contractor cleared that state process. What checks the work itself, once it's in, is the local building office. Most cities and counties in the state call for a permit before the furnace goes in and an inspection after, and that inspection is what confirms the gas line, the venting and the wiring were done right.
Source: West Virginia Legislature
- What size furnace does my house need?
- The right size comes from a load calculation, not a chart based on square footage alone. A contractor measures your home's insulation, window area, ceiling height, and air leakage to figure out how much heat you actually lose on a cold night. An oversized furnace cycles on and off too fast and wears out early. An undersized one runs constantly and still can't keep up when it's 26°F outside. This is worth getting right before installation, not after.
- How do I know it's time to replace my furnace?
- Watch for uneven heat, rooms that stay cold, or a furnace that runs longer each cycle to do the same job it used to do faster. Rising repair calls are another sign, especially if a technician has replaced more than one major part in a short span. Age matters too. An older furnace works harder to do what a new one does easily. Since your home needs heat from October through April, a furnace that struggles in the shoulder months usually fails outright once the cold settles in.
- Is a high-efficiency furnace worth it?
- It depends on how much you run it and what you're comparing it against. Every non-weatherized gas furnace made after November 19, 2015 has to hit at least 80 percent AFUE, so that's the floor, not the top of the range. High-efficiency models go higher than that, meaning less fuel burned for the same heat. With heat needed here from October through April, a furnace has a lot of hours over those seven months to make that difference add up. A contractor can walk through the models available and what each one costs installed for your house.