HVAC Installation in Beckley, WV
A new system here will heat from October through May and cool from June through August every year. Tell us about the house, and a licensed contractor who covers Raleigh County will get in touch.
Tell us about the job
It takes about a minute.
Beckley asks a lot of a heating and cooling system
Eleven months out of the year, a system here is either heating or cooling the house. Winter nights average 25°F from December through February, so a furnace or heat pump runs long and hard for eight months, October through May. Summer only asks three months of it, June through August, with afternoons around 80°F, but that's still real work on the other end.
55.9% of homes in this area heat with electricity, and this county sees real weather. Ten years of records show 22 winter storms and 105 damaging wind events, and statewide, over a third of households lost power for at least a day in 2024. Whatever gets installed has to hold up through that, and most systems come back on their own once the power does.
- 8 months
- October through May, your system heats
- 3 months
- June through August, it cools
- 25°F
- the average winter night it heats against
- 80°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
West Virginia requires HVAC contractors to hold a state license.
The license is issued to the contractor, not to this specific job. West Virginia tested the person or business behind the company before putting their name on a state record, and that record follows them from one job to the next rather than being renewed for each installation.
For a new heating and cooling system, that license is what stands behind the work, but the job still goes through the local building office. In most cities and counties here, installing a new furnace, air conditioner or heat pump needs a permit, and the finished work gets an inspection before it is signed off.
Source: West Virginia Legislature
- When should I replace my HVAC system?
- When it's breaking down more than once a season, or it can't keep up anymore. A furnace working through eight months of heat a year here logs a lot of hours, so an older unit is worth a hard look even if it's still limping along. Rising bills with no other explanation is another sign the system is losing efficiency. If a contractor is already out for a repair, ask them straight whether it makes more sense to fix it or replace it.
- Should I replace my furnace and air conditioner at the same time?
- If they're close in age, yes, it usually makes sense to plan for both. A furnace and AC installed together are matched to work with each other, and pairing an old furnace with a new coil, or the reverse, can cause problems down the line. It's not a rule you have to follow if one unit still has plenty of life left in it. A contractor can look at the age and condition of both and tell you if replacing them together makes sense for your house.
- What happens during an HVAC installation?
- A contractor removes the old furnace and air conditioner or heat pump, then sets the new equipment in place and connects it to your ductwork, electrical, and in most cases a gas or refrigerant line. They'll check the ducts for leaks or sizing problems while they're in there, since a new system connected to bad ductwork won't perform the way it should. Once everything's connected, they test it, run it through its paces, and walk you through the new thermostat or controls. In most cities and counties this work needs a permit from the local building office, and the job isn't finished until it passes inspection.